Precautions for Using Artificial Fog

If further humanArtificial FogDuring the process, if it is found that the water pump head of the creator machine is dripping, it may be due to wear of the water seal of the pump head, and the fundamental reason is that the pump runs dry without water, causing the water seal to overheat and expand under high pressure. In this case, we need to replace the water seal of the pump and also pay attention to protecting the water cutoff of the creator machine. Check whether the sensing switch component has been installed on the controller, and then check if the loose sensing component can be reconnected and fixed. If not, it needs to be replaced in time. Next, I will talk about more precautions regarding artificial fog to help everyone smoothly create the desired effect during the process.

HumanArtificial FogDuring the installation, setting, and maintenance check of the main machine, attention needs to be paid. If the protective software is not installed, or if the controller is set in manual mode, if there is a water cutoff, the sensing switch will not protect the humidifier. Everyone needs to reopen the sewage cutoff sensing switch. Every 250 hours of operation or every two months, the lubricating oil needs to be replaced, and records should be kept along with other maintenance and cleaning to ensure that the main machine maintains good operating conditions, allowing the humidification system to operate more smoothly. The lubricating oil needs to be topped up, and observe that it reaches the 70% full position. At the same time, clean the exhaust holes in the exhaust screw. If the lubricating oil appears milky white, check if the cylinder oil seal is worn. If wear is found, please replace the equipment immediately.

The working pressure of artificial fog is above 100, and at this time, check whether the nozzle is blocked. The method of exclusion can be to clean the spray and replace it after use. HumanArtificial FogIf the working pressure is below 80, check whether the water source is sufficient, whether the filter is clogged, and whether the nozzle is worn or if there is a leak in the pipeline. After ruling out the above situations, we can further investigate the reasons.

HumanArtificial FogThe equipment system is currently the most finely atomized system device with impact atomization particles. It uses water as raw material, utilizing the principle of micropore high-pressure impact atomization. After treatment by the HP-2N biological membrane technology water processor, it effectively removes harmful substances containing active ingredients. Then, through the ITPUMP high-pressure power device, it is automatically controlled and detected, allowing water under high pressure to spray out from the ruby micropores at a speed of 92.9 meters per second, colliding with the atomization needle.